상품명 | [단종] [RPM-73432] B44, B44-1 & B44-2 Front A-arms |
---|---|
상품코드 | #RPM-73432 |
제조사 | RPM |
판매가 | 13,400원 |
현재고 | 품절 |
적립금 | 130원 (1%) |
원산지 | 미국 |
사용연령 | 만14세 이상 |
배송방법 | 택배 |
수량 |
(최소주문수량 1개 이상 / 최대주문수량 0개 이하)
사이즈 가이드수량을 선택해주세요.
위 옵션선택 박스를 선택하시면 아래에 상품이 추가됩니다.
상품명 | 상품수 | 가격 |
---|---|---|
[단종] [RPM-73432] B44, B44-1 & B44-2 Front A-arms | 13400 ( 130) |
할인가가 적용된 최종 결제예정금액은 주문 시 확인할 수 있습니다.
Quick Notes:
– replaces stock Associated #9715
Our first objective with our version of these a-arms was to improve strength and durability without sacrificing rigidity to keep these race-bred machines at the front of the pack. Our design changes still retain all stock suspension geometry yet have been improved structurally to eliminate potential breakage points. We’ve also eliminated slop at the hinge pins and caster blocks. Our box-stock B44.2FT came with hinge pin holes with .005” (.13mm) of clearance in each hinge pin hole! That’s a total of .01” (.26mm) of slop (inside and outside hinge pins combined) before the vehicle ever ran! By tightening up these “loose” areas with our A-arms, the B44’s camber, caster and toe angles are locked in place while improving suspension performance and consistency at the same time.
We also found that the stock anti-sway bar pivot balls molded in the A-arms are .005” (.13mm) undersized. That leads to inadequate performance of the sway-bar system. We rectified that by eliminating the molded ball entirely and replaced it with a more stout, machined pivot ball (not included – see “tech notes” below), with closer tolerances on the ball diameter.
Each RPM A-arm for the B44 is molded in black and comes with our limited lifetime warranty against breakage. When performance counts and the goal is to get across the finish line, you can count on RPM to get you there!
Tech Notes: RPM A-arms for the B44 fit the B44, B44.1, B44.2 & B44.3. Individuals wanting to run a sway bar system must use any standard 4.3mm ball stud such as Associated #6276. We recommend Associated balls studs for the most consistent diameter but any 4.3mm ball stud with a 4-40 x ¼” thread will work.
상품의 사용후기를 적어주세요.
게시물이 없습니다
상품에 대해 궁금한 점을 해결해 드립니다.
게시물이 없습니다